Hi I installed an evo all fort4 in a 2008 ford escape. Everything went well it starts the car with lock unlock lock. But the vehicle will stay running even after the foot brake is pressed. I noticed the brake wire is only an output on the evo all, so hooking this up to the foot brake didnt seem to work. The only way to shut the vehicle off is either wait for the timer to expire or push lock unlock lock again. Is there anyway to make the evo all recognize the foot brake? I was contamplating putting a relay from the positve brake wire to ground the hood pin control, but I would much prefer it to recognize over CAN bus if I can. Thanks!!